NEW | KSV Series Solid State Relay
KSV series is a solid state relay with integrated heat sink, width 30mm or 50mm, with din-rail clip, can be installed on 35mm rail (DIN EN50022), can also be installed on the panel with screws. This product has two control voltages: 4-32VDC or 90-280VAC, load voltage 240VAC, 480VAC or 600VAC, load current is 20A, 30A, 40A, 50A or 75A.
Main Parameters
Dimension(20A/30A) | 78.8mm×30.5mm×112.5mm |
Dimension(40A) | 122mm×50.5mm×110mm |
Dimension(50A/75A) | 153mm×105mm×122.2mm |
Load Voltage | 240V/ 480V / 600VAC |
Control Mode | DC Control / AC Control |
Load Current | 20A / 30A / 40A / 50A / 70A |
Switching Mode | Random-on / Zero-crossing |
Product Highlights
With Integrated Heat Sink
Built-in Over-voltage Protection
Built-in RC Protection
Panel Mount or 35mm Din Rail Mount DIN (EN50022)
LED Indication
Application
Suitable for high and low temperature chambers, plastic machinery, electric injection molding machines, packaging machines and other occasions.
Application Example
In the field of plastic machinery, replacing common panel-mounted SSR such as KSN; KSV has the following advantages:
Parameters | KSN | KSV |
Installation Method | Panel Mount | Din Rail Mount |
Customer selection | It is necessary to select the appropriate heat sink according to the current, and a certain professional ability is required. | The heat sink is integrated, and the data sheet provides the current curve of close installation and spaced installation, and the customer selection is simple. |
Installation Procedures | Panel installation, need to apply thermal grease or thermal pad, install the heat sink and then fix it. | Din rail mount, easy to use and replace. |
Reliability | There is a risk of over-temperature damage to the product due to abnormal installation such as too small heat sink selection, uncoated thermal grease or thermal pad, or loose screws. | The integrated heat sink can be directly installed and used to avoid product failure due to installation problems. |
When mounting relays side by side please see recommended minimum spacing below: